Mazda 626 MX-6 Workshop Manual page 217

9. Turn the throttle sensor to adjust BLUE wire volt­
age within the range specified for the recorded
RED wire voltage.
Specification:
RED wire
voltage (V)
4.50-4.59
4.60-4.69
4.70—4.79
4.80-4.89
4.90—4.99
5.00-5.09
10. Tighten the throttle sensor mounting screws.
11. Recheck that BLUE wire voltage is within specifi­
cation.
12. Hold the throttle valve fully open.
86U04A-192
13. Check that BLUE wire voltage is within specifi­
cation.
Specification:
RED wire
voltage (V)
4.50-4.59
4.60—4.69
4.70—4.79
4.80-4.89
4.90-4.99
5.00-5.09
14. If not correct, replace the throttle sensor.
15. Turn the ignition OFF.
16. Disconnect the SST and reconnect the throttle sen­
sor connector.
17. Disconnect the negative battery terminal and de­
press the brake pedal for at least 5 seconds to elim­
inate the control unit malfunction memory.
86U04A-194
626, MX-6 Revised 10/87
CONTROL SYSTEM
BLUE wire RED wire
voltage (V) voltage (V)
0.37-0.54 5.10-5.19
0.38-0.55 5.20-5.29
0.39-0.56 5.30-5.39
0.40-0.57 5.40-5.49
0.40-0.58 5.50
0.41-0.60
BLUE wire RED wire
voltage (V) voltage (V)
3.58-4.23 5.10-5.19
3.66-4.32 5.20-5.29
3.74—4.41
5.30-5.39
5.40—5.49
3.82—4.51
3.90—4.60 5.50
3.97-4.70
4A
BLUE wire
voltage (V)
0.42-0.61
0.43—0.62
0.44-0.63
0.44—0.64
0.44—0.66
BLUE wire
voltage (V)
4.05—4.79
4.13-4.88
4.21-4.98
4.29-5.07
4.29-5.17
4A-99