Mazda 626 MX-6 Workshop Manual page 478

14. Replace the clips at the end of the driveshafts and
joint shaft with new ones.
15. Install the joint shaft and right driveshaft as follows:
(1) Install and tighten the reamer bolts ® ; then in­
stall and tighten the standard bolts (§).
Tightening torque:
(£) :7—10 N-m
(70—100 cm-kg, 61—87 in-ib)
(D :42—62 N-m
(4.3—6.3 m-kg, 31—46 ft-lb)
(2) Remove the SST and insert the shaft into the
transaxle.
(3) Pull the front hub outward and connect the
driveshaft to the joint shaft.
(4) Push the joint at the differential side to secure­
ly connect the driveshaft to the joint shaft.
Note
a) After installation, pull the front hub outward
to confirm that the driveshaft doesn't come
out.
b)Do not damage the oil seal.
86U07A-219
16. Install the left driveshaft as follows:
(1) Pull the front hub outward and insert the
driveshaft into the transaxle.
(2) Push the joint at the differential side to connect
the driveshaft to the differential side gear.
Note
a) Do not damage the oil seal.
b) After installation, pull the front hub outward
to confirm that the driveshaft doesn't come
out.
17. Install the lower arm ball joints to the knuckles and
tighten the bolts and nuts.
Tightening torque: 43—54 N-m
(4.4—5.5 m-kg, 32—40 ft-lb)
18. Install the under cover.
Note
Before installation, fill the notches with sili­
con as shown in the figure.
Tightening torque: 8—11 N-m
(80—110 cm-kg, 69—95 ft-lb)
626, MX-6 Revised 10/87
7A
INSTALLATION
7 A—81