Driveshaft Installation; Lower Arm Installation; Tie-Rod End Installation; Stabilizer Control Rod Installation - Mazda 626 MX-6 Workshop Manual

Driveshaft
1. Apply grease to the end of the driveshaft.
2. Install the driveshaft and a new clip.
Caution
a) When installing the driveshaft, be careful
not to damage the oil seal.
b) After installation, pull the front hub outward
to confirm that the driveshaft is securely
held by the clip.
Lower Arm
Install the lower arm ball-joint to the knuckle; then tight­
en the lock nut.
Tightening torque:
43—54 N m (4.4—5.5 m-kg, 32—40 ft-lb)
Tie-Rod End
1. Install the tie-rod end to the knuckle.
Tightening torque:
29—44 N m (3.0—4.5 m-kg, 22—33 ft-lb)
2. Install the cotter pin.
Stabilizer Control Rod
Install and adjust the front stabilizer control rods.
Dimension A: 20.1 mm (0.79 in)
Tightening torque:
16—23 N m (1.6—2.3 m-kg, 12—17 ft-lb)
Install the front wheel.
Tightening torque:
88—118 N m (9.0—12.0 m-kg, 65—87 ft-lb)
1
INSTALLATION