Manual Transaxle Inspection - H-Type Mtx (Turbo) - Mazda 626 MX-6 Workshop Manual

INSPECTION
Check the following parts, replace if necessary.
1st, 2nd, 3rd, 4th, and 5th gears
1. Worn or damaged synchronizer cone.
2. Worn or damaged hub sleeve coupling.
3. Worn or damaged teeth.
4. Worn or damaged inner surface or end surface of
gears.
61G07X-182
Primary Shaft Gear and Primary Gear
1. Worn or damaged gear contact surface.
2. Worn or damage splines.
3. Worn teeth.
4. Clogged oil passage.
5. Primary shaft gear run-out.
Run-out: 0.035 mm (0.0014 in) max.
Note
If the shaft gear is replaced, adjust the bear­
ing preload. (Refer to page 7A—67)
Outer diameter:
A. 41.80—41.99 mm (1.646—1.653 in)
B. 36.75—37.00 mm (1.447—1.457 in)
C. 36.17—36.20 mm (1.424—1.425 in)
86U07A-143
inner diameter (gears):
3rd. 47.00—47.02 mm (1.850—1.851 in)
4th. 47.00—47.02 mm (1.850—1.851 in)
5th. 43.00—43.02 mm (1.693—1.694 in)
86U07A-144
7A
INSPECTION
7A-57