Mazda 626 MX-6 Workshop Manual page 462

8. Measure the clearance between the 3rd gear and
primary shaft gear.
If clearance is not within specification, replace any
part which is worn or damaged.
Clearance: 0.150—0.262 mm
(0.059—0.0103 in)
86U07A-163
9. Measure the clearance between the 4th gear and
bearing inner race. If clearance is not within specifi­
cation replace any part which is worn or damaged.
Clearance: 0.150—0.262 mm
(0.0059—0.0103 in)
86U07A-164
Secondary Shaft Gear
1. Install the thrust washer.
2. Install the needle bearing and the 1st gear.
Note
Apply transaxle oil to the needle bearing.
3. Install the synchronizer ring (Refer to page 7A—63)
and clutch hub assembly (reverse gear).
86U07A-165
4. Install the synchronizer ring.
5. Install the ball, gear sleeve and needle bearing.
Note
Apply transaxle oil to the needle bearing.
86U07A-166
7A
ASSEMBLY
7 A—65