Selector
1. Install the primary and secondary shaft bearing out
O uter race
er races into the transaxle case (diaphragm springs
and shims removed).
2. After mounting the clutch housing onto the trans
axle hanger, and set the differential bearing outer
race into the clutch housing.
Next, position a piece of pipe against the outer race
and tap in with a hammer until it contacts the clutch
housing.
3. Assemble the outer races into the SST (selector)
as shown in the figure.
Note
Turn the selector to eliminate the gap indicat
86U07A-251
ed by the arrow in the figure.
4. Set the differential assembly onto the clutch hous
ing, then mount the bearing outer race and the
selector on the differential.
Set the assembled selectors for the primary and
secondary shaft in the clutch housing.
figure.
86U07A-252
5. Set the SST (collars) in the positions shown in the
86U07A-253
86U07A-254
626, MX-6 Revised 10/87
Mount the shaft gear assemblies as shown in the
figure.
Install the transaxle case then tighten the SST
(bolts) to the specified torque.
Tightening torque:
37—52 Nm (3.8—5.3 m-kg, 27—38 ft-lb)
7A
ASSEMBLY
7A-37