Mazda 626 MX-6 Workshop Manual page 30

1
ON-VEHICLE MAINTENANCE (CYLINDER HEAD)
1 -2 0
Installation note
Cylinder head
1. Thoroughly remove all dirt and oil from the top of
the cylinder block with a rag.
2. Place a new cylinder head gasket in position.
3. Set the cylinder head in place.
4. Apply engine oil to the bolt threads and seat faces.
5. Tighten the cylinder head bolts in two or three steps
in the order shown in the figure.
Tightening torque:
80—86 Nm (8.2—8.8 m-kg, 59—64 ft-lb)
86U01X-036
Cylinder head cover
1. Apply silicon sealant to the shaded area shown in
the figure.
2. Install the cylinder head cover.
Tightening torque:
6—8 N m (60—80 cm-kg, 52—69 in-lb)
86U01X-037
Timing belt
1. Align the " f 1 " mark of the camshaft pulley with
the front housing timing mark.
2. Install the timing belt. (Refer to TIMING BELT of
ON-VEHICLE MAINTENANCE.)
86U01X-038