Mazda 626 MX-6 Workshop Manual page 467

7A
ASSEMBLY
7A-70
1. Put the outer race into the SST.
2. Mount the secondary shaft gear assembly as
shown.
Note
The secondary shaft selector touches the
49 G030 381 differential gear, so the secondary shaft bear­
ing preload adjustment should be done
separately from for the primary shaft and
differential assembly.
76G07A-640
Note
Install with the SST in the positions in the
figure.
3. Install the transaxle case and set the SST.
Tightening torque: 37—52 N-m
4. To seat the bearings, mount the SST on parts (A)
and (B) of the selector, and then turn the selector
so the gap is widened.
Move the bar by hand until the selector can no
longer be turned, and then turn it in the reverse
direction until the gap is eliminated.
5. Manually expand the selector until the selector no
longer turns.
Note
Check that each shaft turns smoothly.
626, MX-6 Revised 10/87
(3.8—5.3 m-kg, 27—38 ft-lb)