Front bracket
Pulley
Locknut
1. Place a soldering iron (200W) on the bearing box
for 3 or 4 minutes to heat it to about 50—60°C
(122—140°F).
Pull out the three bolts, and then insert a screw
driver between the stator and front bracket and
separate them.
Note
a) If the bearing box is not heated, the bear
ing cannot be pulled out because the rear
bearing and rear bracket fit together very
tightly.
b) Be careful not to force the screwdriver in
too far. The stator may become scratched.
86U05X-020
63U05X-999
2. Separate the rear and front sections.
Note
Be careful not to lose the stopper spring that
fits around the circumference of the rear
bearing.
5BU05X-057
3. Place the rotor in a vise and loosen the pulley nut,
then disassemble the pulley, rotor, and front
bracket.
Rotor
86U05X-021
ALTERNATOR 5
5 -1 3