Mazda 626 MX-6 Workshop Manual page 482

TRANSAXLE CONTROL
Spring
Remove the spring by prying on the hooked part of
the spring with a screwdriver.
INSPECTION
Check the following, and replace if necessary:
1. Bent control rod.
2. Wear, damage, or malfunction of any joint.
3. Damaged gear shift lever ball.
4. Weak spring.
5. Wear or damage of bushing.
61G07X-192
INSTALLATION
Install in the reverse order of removal and note the
following:
Extension Bar
First, install the extension bar to the floor, and then
install it onto the transaxle.
Tightening torque:
31—46 N m (3.2—4.7 m-kg, 23—34 ft-lb)
Bracket Installation
Tighten the bracket installation nuts to the specified
torque.
Tightening torque: 7—10 N-m
(70—100 cm-kg, 61—87 in-lb)
626, MX-6 Revised 10/87
7A
7A-85