Checking The Accessory Kit; Rackmount Installation; Checking The Rail Kit Accessories - Eaton 9130 User Manual

Checking the Accessory Kit

Verify that the following additional items are included with the UPS:
UPS user's guide
l
Quick start instructions
l
Software Suite CD
l
USB cable
l
Serial cable
l
Power cord (for models without an attached power cord)
l
If you ordered an optional Extended Battery Module (EBM), verify that the following additional item is included
with the EBM:
EBM user's guide
l

Rackmount Installation

The Eaton 9130 rackmount cabinet comes with all of the hardware required for installation in a standard
19-inch rack or JIS seismic rackmount configuration with square and round mounting holes. The rail
assemblies adjust to mount in Standard 19-inch racks with front to rear rail distances from 61–76 cm
(24–30 inches) deep.

Checking the Rail Kit Accessories

Verify that the following rail kit items are included for each cabinet:
Left rail assembly:
l
- Left rail
- Rear rail
- (3) M4x8 pan-head screws
Right rail assembly:
l
- Right rail
- Rear rail
- (3) M4x8 pan-head screws
Rail hardware kit:
l
- (10) M6x16 pan-head screws
- (10) M6 cage nuts
- (2) rear stop brackets
- (2) M3x8 pan-head screws
Mounting bracket kit:
l
- (2) mounting brackets
- (8) M4x8 flat-head screws
NOTE Discard the EBM user's guide if you are installing the EBM with a new UPS at the
same time. Use the UPS user's guide to install both the UPS and the EBM.
NOTE Rackmount models must only be installed horizontally in the rack. Do not mount the
rackmount models in tower mode (vertically).
Eaton 9130 700/3000 VA UPS User's Guide 164201718—Rev 7 www.eaton.com/powerquality
Installation
13