Ebm Setup; Checking The Ebm Accessory Kit - Eaton Powerware 9140 User Manual

EBM Setup

Eaton 9140 UPS (7.5–10 kVA) User's Guide
The Eaton 9140 EBM comes with all hardware required for installation in
a standard EIA or JIS seismic rack-mount configuration with square or
round mounting holes. The rail assemblies adjust to mount in 19-inch
panel racks from 24 to 33 inches deep (28.5 to 32 inches deep if
installing the optional seismic mounting brackets).

Checking the EBM Accessory Kit

If you purchased an optional EBM, verify that the following items are
included with the EBM:
S
Mounting brackets and fasteners (if not already installed):
- (2) front mounting brackets
- (2) rear mounting brackets
- (12) M4 flat-head screws, plus (2) extra
S
Rails and fasteners:
- (2) sliding rail assemblies (left and right)
- (4) adapter plates (for 7.1 mm round hole)
- (4) adapter plates (for 9.5 mm square hole)
- (16) M5 machine screws, plus (2) extra
- (2) M6 machine screws, plus (2) extra
- (2) M6 clip nuts for racks with round holes, plus (2) extra
- (2) M6 cage nuts for racks with square holes, plus (2) extra
- (8) M4 machine screws with (8) M4 locknuts, plus (2) extra of each
S
EBM user's guide
S
Optional seismic mounting brackets and fasteners:
- (2) EBM seismic mounting brackets
- (4) wing bolts, plus (1) extra
- (4) M6 machine screws, plus (2) extra
NOTE Discard the EBM user's guide if you are installing the EBM with a new UPS at the
same time. Use the UPS user's guide instead to install both the UPS and the EBM.
S 164201622 Rev 3 www.eaton.com/powerquality
INSTALLATION
23