Chapter 10. System Management - Samsung WEC8500 Operation Manual

2600-00FK1RGA4 Ver.
CHAPTER 10.
In this chapter, the various functions used by an operator to manage the system and
troubleshooting method are described. In addition, the configurations required for system
operation such as system configuration management, resource management, alarm
management, and package management, etc. and checking methods are described.
10.1 SNMP Configuration
10.1.1 SNMP Community
To use an external management server or to manage the system through a web server after
initial system installation, you must configure the SNMP community using CLI.
When creating the SNMP community, you can restrict configuration privilege by allocating
the access right such as read-only or read-write and can also restrict an IP to connect.
You can configure maximum 10 SNMP communities.
Configuration using CLI
To add a SNMP community, execute the command as follows:
1) Go to configure mode of CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Use the 'snmp community' command to add a SNMP community.

snmp community [COMMUNITY_NAME] [ACCESS] [IP_VERSION]
[IP_ADDRESS] [NET MAST]
Parameter
COMMUNITY_NAME
ACCESS
IP_VERSION
IP_ADDRESS, NETMAST
3) To check the created SNMP community, use the 'show snmp community' command.
© SAMSUNG Electronics Co., Ltd.
3.0
System Management
Name of a community to add
Access privilege (rw/ro)
- rw: read-write privilege
- ro: read-only privilege
IP address version type (v4/v6)
IP address area that can be connected

CHAPTER 10. System Management

Description
page 327 of 496