2600-00FK1RGA4
Ver.
5.5
Radio Service Configuration
The APC supports WLAN-based radio configuration. You can enable or disable WMM
based on WLAN and change DTIM and station idle timeout.
Configuration using CLI
1) Go to configure wlan-radio-service mode of CLI.
APC# configure terminal
APC/configure# wlan-radio-service
APC/configure/wlan-radio-service#
2) Configure whether to enable or disable WMM.
wmm-mode [WLAN_ID] [MODE]
Parameter
WLAN_ID
MODE
3) Configure DTIM.
dtim [WLAN_ID] [ DTIM]
Parameter
WLAN_ID
DTIM
4) Configure station idle timeout.
sta-idle-timeout [WLAN_ID] [TIMEOUT]
Parameter
WLAN_ID
TIMEOUT
5) To check the configured information, use the 'show wlan-radio-service' command.
© SAMSUNG Electronics Co., Ltd.
3.0
WLAN ID (range: 1-240)
WMM configuration mode (disable/enable)
WLAN ID (range: 1-240)
Beacon DTIM: 1~255(default: 1)
WLAN ID (range: 1-240)
Station idle timeout (range: 30-3600, unit: 15 s, default: 300)
CHAPTER 5. WLAN Management
Description
Description
Description
page 204 of 496