2600-00FK1RGA4
Ver.
WEC8500# configure terminal
WEC8500/configure# ap-group apg_01
WEC8500/configure/ap-group apg_01# add-wlan 1
3) Configure an interface group to which the WLAN service will be provided.
Several VLAN interfaces can be added to an interface group, and the WLAN service is
available only through the interface..
if-group [INTERFACE_GROUP_NAME]
4) Configure a SSID. The SSID is an ID used to connect to each wireless terminal to
provide the WLAN service.
Make sure to configure a SSID to use the WLAN service.
ssid [SSID_NAME]
5) Configure whether to apply the WLAN service.
WEC8500/configure/wlan 1#enable
To apply the various WLAN services to multiple wireless terminals, create the
WLAN service in a profile format. Once the WLAN service is started, make each
AP use the WLAN service by downloading the profile.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<WLANs> menu in the sub-menus. Select a WLAN ID to change in the WLANs screen
and go to the <General> tab. In the screen, you can use various functions such as adding or
deleting a WLAN.
© SAMSUNG Electronics Co., Ltd.
3.0
Figure 76. WLAN basic configuration (1)
CHAPTER 5. WLAN Management
page 165 of 496