2600-00FK1RGA4
Ver.
6.3
802.11h Configuration
The APC supports the configuration and transmission power limitation for the Dynamic
Frequency Selection (DFS) function in an AP. When the AP detects radar, an event is sent
to the WEM and a detouring channel can be configured in the AP.
Configuration using CLI
For channel switching announcement related configuration and power constraint value
configuration in an AP, execute the command as follows:
1) Go to configure 80211h configuration mode of CLI.
APC# configure terminal
APC/configure# 80211h
APC/configure/80211h#
2) Configure the 802.11h information.
channel-switch [MODE] [RESTRICTION] [SWITCH COUNT]
Parameter
MODE
RESTRICTION
SWITCH COUNT
3) Configure the transmission power of a wireless terminal.
power-constraint [VALUE]
Parameter
VALUE
4) To check the configuration information, use the 'show 80211h configuration' command.
© SAMSUNG Electronics Co., Ltd.
3.0
Whether the switching announcement function is enabled/disabled
Whether the channel packet transmission restriction mode is
enabled (disable/enable)
Waiting time until channel switching announcement
CHAPTER 6. Wi-Fi Configuration
Description
Description
Transmission power(0 – 31 dB)
page 221 of 496