2600-00FK1RGA4
Ver.
7.8
Remote Packet Capture
APC can capture a packet exchanged between the wireless terminals on a remote PC in
real-time by using the remote packet capture protocol.
To configure the remote packet capture function, you must go to the pcap mode by
executing the command as follows:
APC# configure terminal
APC/configure# pcap
Configuring the MAC address of a wireless terminal
Configures the MAC address of a wireless terminal whose packets will be captured.
(Maximum 100 packets)
APC/configure/pcap# filter station-mac [MAC_ADDRESS]
APC/configure/pcap# filter enable-station-mac [INDEX]
Parameter
MAC_ADDRESS
INDEX
Configuring AP MAC address
Configure the MAC address of an AP whose packets will be captured (maximum 10).
APC/configure/pcap# filter ap-mac [MAC_ADDRESS]
APC/configure/pcap# filter enable-ap-mac [INDEX]
Parameter
MAC_ADDRESS
INDEX
Configuring Filtering Mode
Capture target can be specified by configuring the filtering mode
APC/configure/pcap# mode [FILTERING MODE]
Parameter
FILTERING Mode
© SAMSUNG Electronics Co., Ltd.
3.0
MAC address (11:22:33:44:55:66 format)
Index number of MAC address (range: 1-10)
MAC address (11:22:33:44:55:66 format)
Index number of MAC address (range: 1-10)
station-only-Use only the configured station MAC information.
ap-only-Use only the configured AP MAC information.
station-or-ap-Use the both configured AP and station MAC and it
is captured when either one is matched.
CHAPTER 7. WLAN Additional Services
Description
Description
Description
page 254 of 496