Samsung WEC8500 Operation Manual page 92

2600-00FK1RGA4 Ver.
5) Detail Configuration
Configuration using CLI
Additional explanations for Area. Operator can configure authentication, default-cost, or
shortcut.
WEC8500/configure/router/ospf 2# area 2 ?
authentication
default-cost
stub area
filter-list
nssa
range
(border routers only)
shortcut
stub
virtual-link
Configuring authentication
Operator can select whether to use authentication or message-digest function.
WEC8500/configure/router/ospf 2# area 2 authentication ?
message-digest
<cr>
WEC8500/configure/router/ospf 2# area 2 authentication message-
digest ?
<cr>
WEC8500/configure/router/ospf 2# area 2 authentication message-digest
Configuring Default-cost
Configure a value between 0 and 1677215 as a default-cost. However, operator can
configure the default-cost value in AREA ID whether a stub or NSSA is configured.
If you try to configure the default-cost in an ID where neither the two items are configured,
the following error phrase is displayed.
'% The area is neither stub, nor NSSA'
WEC8500/configure/router/ospf 2# area 0.0.0.1 default-cost ?
0 - 16777215
WEC8500/configure/router/ospf 2# area 0.0.0.1 default-cost 3 ?
<cr>
WEC8500/configure/router/ospf 2# area 0.0.0.1 default-cost 3
© SAMSUNG Electronics Co., Ltd.
3.0
Enable authentication
Set the summary-default cost of a NSSA or
Filter networks between OSPF areas
Specify a NSSA area
Summarize routes matching address/mask
Configure the area's shortcutting mode
Configure OSPF area as stub
Define a virtual link and its parameters
Use message-digest authentication
Stub's advertised default summary cost
CHAPTER 3. Data Network Function
page 92 of 496