Samsung WEC8500 Operation Manual page 151

2600-00FK1RGA4 Ver.

edge-ap: Configures whether to enable the Edge AP function.

fragment-size [SIZE]: Configures a fragment size based on MTU to prevent the
fragmentation of a CAPWAP packet that is transmitted by an AP to the APC.

ip-mode [dhcp/static/ap]: Configures the IP address of an AP to DHCP, Static or AP
Followed.
−
dhcp: Configures the AP IP operation type to DHCP
−
static: Configures the AP IP operation type to static
−
ap: Operates with an IP configured in an AP

location [STRING]: Configures the information of location where an AP is installed.

mac [MAC_ADDRESS]: Configures the MAC address of an AP

max-echo-retransmit [COUNT]: Configures the maximum number of
retransmission times of an echo request message.

max-retransmit [COUNT]: Configures the maximum number of retransmission
times of a CAPWAP control message.

Name [STRING]: Configures an AP name.

native-vlanId [VLAN_ID]: Configures the native VLAN in an AP.

primary-apc [APC_AME]: Configures the name of a primary APC.

secondary-apc [APC_AME]: Configures the name of a secondary APC.

tertiary-apc [APC_AME]: Configures the name of a tertiary APC. The WEC8050
model does not support the tertiary-apc function.

repeater-whitelist [MAC ADDRESS]: Adds the Repeater AP Whitelist.

report-interval [INTERVAL]: Configures the time interval for an AP to transmit the
description error to the APC (Unit: seconds)

retransmit-interval [INTERVAL]: Configures the waiting time until the AP
retransmits a CAPWAP control message when there is no reply from the APC (unit:
seconds)

ssh-enable: Configures whether to enable the SSH server of an AP.

static-ip [IP_ADDRESS] [NETMASK] [GATEWAY]: Configures the static IP
address of an AP.

statistics-timer [TIMER]: Configures the time interval of transmitting the statistics
information provided by CAPWAP (unit: seconds)

sync-group: Configures whether to follow the profile configuration of ap-group
where the AP is belonged.

telnet-enable: Configures whether to enable the telnet server of an AP.

time-config: Configure the time synchronization function per AP. Refer to 'AP Time
Synchronization per Group'.

vlan-support: Configures whether to enable the native VLAN of an AP.

wlan-vlanId [VLAN_ID]: Configures the VLAN ID of a remote AP WLAN that
performs local bridging.
3) To check the information of a configured AP profile, use the 'show ap detail
[AP_NAME]' command.
© SAMSUNG Electronics Co., Ltd.
3.0
CHAPTER 4. AP Connection Management
page 151 of 496