Samsung WEC8500 Operation Manual page 129

2600-00FK1RGA4 Ver.

discovery-by-multicast: Configures whether to allow connection to CAPWAP
multicast. (The 'add-multicast-if' must be configured before configuring whether to
allow multicast connection.)

discovery-del-timer: If the Join message is not received after receiving a Discovery
message, this configures the timeout to discard the previously received Discovery
messages.

dtls-session-delete [TIMER]: Configures the waiting time to disconnect DTLS when
releasing the connection between an AP and CAPWAP.

retransmit-interval [INTERVAL]: Configures the re-transmission interval of
CAPWAP control packet retransmission.

max-retransmit [COUNT]: Configures maximum number of retransmission when
there is no answer for CAPWAP control packet transmission.

wait-dtls-timer [TIMER]: Configures the maximum time until the AP waits without
receiving the DTLS handshake message from the APC (RFC 5415) (default: 60 seconds)

wait-join-timer [TIMER]: Configures the maximum time until the APC receives the
Join message after finishing DTLS handshake (RFC 5415) (default: 60 seconds)

window-size [size]: Configures the maximum number of packets that can be
transmitted without response during CAPWAP control packet transmission.
An example of entering a command is shown below.
WEC8500/configure/apc/capwap# date-check-timer 30
3) To check the configured CAPWAP information, use the 'show apc capwap summary'
command.
© SAMSUNG Electronics Co., Ltd.
3.0
CHAPTER 4. AP Connection Management
page 129 of 496