Spanning Tree - Samsung WEC8500 Operation Manual
Access point controller
Hide thumbs
Also See for WEC8500:
- Operation manual (689 pages) ,
- Maintenance manual (88 pages) ,
- Operation manual (680 pages)
Table of Contents
Advertisement
2600-00FK1RGA4
Ver.
3.3.3
Spanning Tree
Configuration using CLI
To set up spanning tree related functions, go to configure mode by executing the following
command.
WEC8500# configure terminal
The related command is as follows.
[bridge forward-time]
Configures the forward time of a bridge. The 'no' parameter is used for default
configuration.
bridge 1 forward-time [FORWARD_DELAY]
no bridge 1 forward-time
Parameter
FORWARD_DELAY
[bridge hello-time]
Configures the hello time of a bridge. The time required when a bridged LAN is changed to
Bridge Protocol Data Units (BPDUs) is called as hello-time. The 'no' parameter is used for
default configuration.
bridge 1 hello-time [HELLOTIME]
no bridge 1 hello-time
Parameter
HELLOTIME
[bridge instance priority]
Configures the bridge priority of MST instance. The 'no' parameter is used to delete
priority.
bridge 1 instance [INSTANCE_ID] priority [BRIDGE_PRIORITY]
no bridge 1 instance [INSTANCE_ID]
Parameter
INSTANCE_ID
BRIDGE_PRIORITY
© SAMSUNG Electronics Co., Ltd.
3.0
Instance ID (range: 1-64)
Bridge priority (range: 0-61440)
CHAPTER 3. Data Network Function
Description
Forward time delay (range: 4-30 s, default: 15)
Description
Hello BPDU interval (range: 1-10 s)
Description
page 57 of 496
Advertisement
Chapters
Table of Contents
