2600-00FK1RGA4
Ver.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller> <Ports> menu in the sub-menus. Operator can configure the ports.
The Ports initial window is shown below.
Operator can check the current status of each port.
The auto-nego, speed, or duplex can be configured only when the cable type is
Copper.
They cannot be configured if the cable type is Optic (The auto-nego should
always be enabled whether the cable type is copper or optic).
© SAMSUNG Electronics Co., Ltd.
3.0
Figure 20. Port Management Window
CHAPTER 3. Data Network Function
page 45 of 496