2600-00FK1RGA4
Ver.
5.4
DHCP Configuration
The DHCP service of APC consists of DHCP server, DHCP relay, and DHCP proxy.
5.4.1
DHCP Server
5.4.1.1
DHCP Server Configuration
A DHCP server in the APC dynamically allocates an IP address to a client.
Configuration using CLI
1) Go to configure mode of CLI.
WEC8500# configure terminal
WEC8500/configure #
2) To enable or disable the DHCP server, enter the 'ip dhcp' command. Use 'no' in front
of the command to disable the configuration.
ip dhcp enable
no ip dhcp enable
3) To check configuration information, use the 'show ip dhcp' command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<DHCP> <Internal Server> menu in the sub-menus.
Enable/Disable the DHCP SERVER SERVICE item in the Internal Server window to
enable or disable a DHCP server.
© SAMSUNG Electronics Co., Ltd.
3.0
Figure 89. DHCP server configuration
CHAPTER 5. WLAN Management
page 189 of 496