Replacing The Power Supply - Gateway 910 Series System Manual

Replacing the power supply

When replacing the power supply, order a power supply replacement from
Gateway.
To remove the power supply:
1
Observe the safety and ESD precautions in "Preventing static electricity
discharge" on page 15.
2
Turn off the server, then disconnect the power cord(s), modem cable (if
installed), and all external devices.
3
Remove the cover panel. (See "Removing the cover panel" on page 17.)
4
Place the case in the upright position.
5
Disconnect the power supply connectors from all internal devices
including the system board, 3.5-inch diskette drive, the CD drive, and
all hard drives.
6
Remove the cable supports securing the power supply cables to the
chassis, if any.
Replacing the power supply
55