Gateway 910 Series System Manual page 39

6
Remove the metal EMI shield by placing a finger through the hole and
pulling the shield out. Save the shield so that you can replace it if you
remove the added drive.
Caution Your server was designed to adhere to electromagnetic
interference requirements and the EMI shield is an integral
part of the server. Installing an approved drive should
continue to maintain those standards. If you remove the
drive you must reinstall the shield.
7
Set the drive jumpers for the device to the appropriate settings (refer to
your drive documentation for jumper settings).
8
Push the drive release latch toward the back of the chassis (unlocked
position).
5.25-inch
EMI shield
3.5-inch
EMI shield
Replacing or adding drives
31