Video Problems - Gateway 910 Series System Manual

Video problems

The server is running but the screen is blank
Probable cause
The monitor is not turned on
The monitors data cable is
not connected
The connector or cable is
damaged
The monitor is defective
The monitor brightness and
contrast controls are turned
down
The DIMM is not seated
properly, indicated by a beep
The image on the screen is dim or difficult to read
Probable cause
The monitor brightness and
contrast controls are turned
down
Sunlight is glaring off the
display
The monitor may be old
84
Troubleshooting
Solution
Make sure the monitor is plugged in and turned
on. If the monitor is turned on, the green power
LED should illuminate.
Make sure the monitor data cable is connected
to the video controller on the back of the
server.
Check the connector and cable for bent or
damaged pins.
Connect a working monitor to the server.
Adjust the brightness and contrast knobs to the
center position.
Open the server and reseat the loose the
DIMM.
Solution
Adjust the brightness and contrast knobs until
the text becomes clear.
Position the monitor away from the sun or a
window.
Replace the monitor.