Replacing The Cd Drive - Gateway 910 Series System Manual

Replacing the CD drive

All drives are secured in the chassis by a drive release latch on the side of the
drive bays. The CD drive is included in the original configuration. If you need
to replace the CD drive, perform the following instructions.
To remove the CD drive:
1
Observe the safety and ESD precautions in "Preventing static electricity
discharge" on page 15.
2
Turn off the server, then disconnect the power cord(s), modem cable (if
installed), and all external devices.
3
Remove the cover panel. (See "Removing the cover panel" on page 17.)
4
Remove the bezel. (See "Removing the bezel" on page 19.)
5
Disconnect the power, audio, and data cables, noting their locations and
orientations. (You will reconnect these cables after you install the new
drive.)
6
Push the drive release latch toward the back of the server (unlocked
position).
7
Pull the drive out of the chassis and place it in an antistatic container.
Replacing or adding drives
25