Gateway 910 Series System Manual page 37

To install the diskette drive:
1
Remove the new diskette drive from its antistatic container, and place it
component-side up on an antistatic surface.
2
Set the drive jumpers (if any) on the new drive to the appropriate settings
(refer to your drive documentation for jumper settings).
3
Align the drive with the open bay, then slide it into the bay until it is
positioned correctly with the bezel.
Important
4
Push the drive release latch forward (locked position) to secure the drive
in the bay.
5
Connect the power and data cables. Make sure the cables are in their
original positions.
6
Reinstall the bezel. (See "Reinstalling the bezel" on page 21.)
7
Reinstall the cover panel. (See "Reinstalling the cover panel" on page 22.)
8
Reconnect external devices, the power cord(s), and the modem cable (if
installed), then turn on the server.
9
Run the BIOS Setup utility to make sure that the server recognizes the
diskette drive. (See "About the BIOS Setup utility" on page 57.)
You may want to install the bezel temporarily to see if the
drive is properly aligned. Adjust the drive as needed, then
remove the bezel.
Replacing or adding drives
29