Gateway 910 Series System Manual page 34

To install the CD drive:
1
Remove the new CD drive from its antistatic container, and place it
component-side up on an antistatic surface.
2
Set the drive jumpers (if any) on the new drive to the appropriate settings
(refer to your drive documentation for jumper settings).
3
Align the drive with the open bay, then slide it into the bay until it is
positioned correctly with the bezel.
Important
4
Push the drive release latch forward (locked position) to secure the drive
in the bay.
5
Connect the power, data, and audio cable. Make sure the cables are in
their original positions.
6
Reinstall the bezel. (See "Reinstalling the bezel" on page 21.)
7
Reinstall the cover panel. (See "Reinstalling the cover panel" on page 22.)
26
Replacing or Adding System Components
You may want to install the bezel temporarily to see if the
drive is properly aligned. Adjust the drive as needed, then
remove the bezel.
Drive
release latch