Gateway 910 Series System Manual page 56

9
Insert the bottom edge of the new expansion card (the keyed edge with
the contacts) into the slot on the system board, then push in firmly to
seat the card. Release the card retainer to secure the card in place.
10
Reinstall the thumbscrew to secure the card retainer.
11
Connect cables to the card, if required.
12
Reinstall the cover panel. (See "Reinstalling the cover panel" on page 22.)
13
Reconnect external devices, the power cord(s), and the modem cable (if
installed), then turn on the server.
You may need to reconfigure your server after installing some expansion cards.
You may also need to install software that came with the card. Refer to the
card documentation for additional information.
48
Replacing or Adding System Components