Gateway 910 Series System Manual page 42

8
Place the old drive in an antistatic bag or container.
To install the hard drive:
1
Remove the new hard drive from its antistatic container, and place it
component-side up on an antistatic surface.
2
Set the drive jumpers on the new drive to the appropriate settings (refer
to your drive documentation for jumper settings).
3
Align the drive with an open bay in the drive cage. Make sure that the
data and power connectors on the drive face outward, then slide the drive
into the cage.
4
Push the drive release latch to secure the drive in place (locked position).
5
Connect the power and data cables to the drive.
6
Reinstall the cover panel. (See "Reinstalling the cover panel" on page 22.)
7
Reconnect external devices, the power cord(s), and the modem cable (if
installed), then turn on the server.
8
Run the BIOS Setup utility to make sure that the server recognizes the
drive. (See "About the BIOS Setup utility" on page 57.)
34
Replacing or Adding System Components