Gateway 910 Series System Manual page 64

7
While supporting the power supply with one hand, pull down on the
plastic power supply release latch at the front end of the power supply.
8
Slide the power supply slightly forward, then let it drop down slightly
and remove it from the chassis.
To install the new power supply:
1
Make sure that the new power supply matches the one you removed. The
specifications, wattage, and power output connectors should be the same.
2
Make sure that the red voltage switch on the back of the new power
supply is set to the proper voltage for your area.
3
Place the new power supply in position inside the chassis and push the
power supply release latch up and into place. The latch will snap firmly
into place.
4
Reconnect the power connectors to all internal devices.
5
Reinstall the cover panel. (See "Reinstalling the cover panel" on page 22.)
6
Reconnect external devices, the power cord(s), and the modem cable (if
installed), then turn on the server.
56
Replacing or Adding System Components
Power supply
release latch