Replacing The Processor - Gateway 910 Series System Manual

Replacing the processor

The server is compatible with the Intel
processors with 100 or 133 MHz front side bus (FSB). Processor and bus speed
are automatically detected by the server. There are no system board jumpers
to set. Whenever you replace the processor, you should install the most
current version of the BIOS as well (see "Updating the BIOS" on page 61).
When replacing a processor, order a processor replacement from Gateway. The
kit includes the processor and a heatsink.
Caution
To replace the processor you must perform the following tasks:
Remove the heatsink
Remove the processor
Install the new processor
Replace the heatsink
To remove the heatsink:
1
Observe the safety and ESD precautions in "Preventing static electricity
discharge" on page 15.
2
Turn off the server, then disconnect the power cord(s), modem cable (if
installed), and all external devices.
3
Remove the cover panel. (See "Removing the cover panel" on page 17.)
Caution
40
Replacing or Adding System Components
A heatsink must be installed on the processor. Installing
a processor without a heatsink could result in damage to,
or failure of, the processor.
The processor may be hot if you recently turned off the
server.
® ™
Celeron or Pentium
®
III, socketed