Table of Contents
Advertisement
Replacing the hard drive
The hard drive is included in the original configuration. If you need to replace
the hard drive, perform the instructions that follow.
To remove the hard drive:
1
Observe the safety and ESD precautions in "Preventing static electricity
discharge" on page 15.
2
Turn off the server, then disconnect the power cord(s), modem cable (if
installed), and all external devices.
3
Remove the cover panel. (See "Removing the cover panel" on page 17.)
4
Place the server in the upright position.
5
Disconnect the power and data cables from the back of the drive, noting
their locations and orientations. (You will reconnect these cables after you
install the new drive.)
6
Pull the drive release latch toward the open side of the chassis (unlocked
position).
7
Pull the drive out of the drive cage.
Drive
release latch
Replacing or adding drives
33
Advertisement
Table of Contents
Troubleshooting
