Gateway 910 Series System Manual page 40

9
Align the drive with the open bay, then slide it into the chassis until it
is positioned correctly with the bezel.
Important
10
Push the drive release latch forward (locked position) to secure the drive
in the bay.
11
Connect the power, data, and audio (if applicable) cables to the back of
the drive.
12
Reinstall the bezel. (See "Reinstalling the bezel" on page 21.)
13
Reinstall the cover panel. (See "Reinstalling the cover panel" on page 22.)
14
Reconnect external devices, the power cord(s), and the modem cable (if
installed), then turn on the server.
15
Run the BIOS Setup utility to make sure that the server recognizes the
drive. (See "About the BIOS Setup utility" on page 57.)
32
Replacing or Adding System Components
You may want to install the bezel temporarily to see if the
drive is properly aligned. Adjust the drive as needed, then
remove the bezel.
Drive
release latch
5.25-inch
device
3.5-inch
device