Gateway 910 Series System Manual page 62

3
Install the retaining thumbscrew and carefully tighten it.
4
Reinstall the memory. (See "Replacing or adding memory" on page 37.)
5
Reinstall the processor. (See "Replacing the processor" on page 40.)
6
Reinstall the expansion cards. (See "Adding or replacing expansion cards"
on page 44.)
7
Reconnect all of the cables you disconnected when you removed the old
system board.
8
Reinstall the cover panel. (See "Reinstalling the cover panel" on page 22.)
9
Reconnect external devices, the power cord(s), and the modem cable (if
installed), then turn on the server.
10
Start the BIOS Setup utility by pressing F1.
11
Select
Load Optimal Defaults
that you wrote down in Step 2.
54
Replacing or Adding System Components
from the Exit menu, then type in the settings