Replacing The Power Supply - Gateway 920 User Manual

Replacing the power supply

Warning
To replace the power supply:
1
Follow the instructions in
page 41.
2
Open the server case by following the instructions in
case" on page
3
Disconnect the power supply cables from all components, noting their
locations and orientation. (You will reconnect the cables after you install
the new power supply.)
4
Pull the power supply retention clip away from the power supply.
The power supply in this server contains no
user-serviceable parts. Only a qualified computer
technician should service the power supply.
Your server is supplied with a 3-wire AC power cord fitted
with the correct plug style for your region. If this plug does
not match the connector on your surge protector, UPS, or
wall outlet, do not attempt to modify the plug in any way.
Use a surge protector, UPS, or wall outlet that is
appropriate for the supplied AC power cord.
"Preventing static electricity discharge" on
42.
www.gateway.com
Replacing the power supply
"Opening the server
61