Gateway 910 Series System Manual page 97

Error message
Invalid password
Keyboard clock line failure
Keyboard controller failure
Keyboard not detected
Keyboard stuck key failure
Memory errors were detected
while the system powered up
Memory size error
Non-system disk or disk error
Not enough memory
Solutions
Enter your password again, making sure to
enter it correctly. Be aware that some
passwords are case sensitive.
If you do not know the password, you may
need to reinstall the software you are trying to
access.
Startup passwords are stored in BIOS. If this
password has been set and you do not know
it, you may be able to reset the password
through system board jumper settings.
Try a working keyboard.
Make sure the keyboard is compatible with the
server. You may have to change the switch
setting to AT.
Try a working keyboard.
Make sure the keyboard is compatible with the
server. You may have to change the switch
setting to AT.
See "The keyboard does not work" on page 83
for a possible solution.
Turn off the server, then check the keyboard
cable.
Remove any objects that may be resting on the
keyboard, then restart the server.
Check for sticky keys. Clean the keyboard if
necessary.
See "The server detected memory errors
during start up" on page 77 for a possible
solution.
Enter the BIOS Setup utility, then save the
memory configuration.
Eject the diskette, then press E
If the diskette is bootable, check it for errors.
Close all programs that are not currently in
use.
.
NTER
Error messages
89