Gateway 910 Series System Manual page 61

System components removed for clarity
Back
10
Remove the retaining thumbscrew securing the board to the chassis.
11
Slide the system board toward the front of the chassis to disengage the
stand-offs from the chassis, then lift the front edge of the board and
remove it carefully.
12
Place the system board in an antistatic container.
To install the system board:
1
Holding the system board by the top and bottom edges, place it in the
case by aligning the stand-offs on the board with the mounting holes
on the right side of the case. Be careful to keep the cables clear, so that
they do not get caught under the system board.
2
Slide the board toward the back of the chassis to engage the stand-offs
and to insert the I/O connectors through the back panel.
Replacing the system board
Front
Retaining
thumbscrew
53