Gateway 910 Series System Manual page 91

The keyboard does not work
Probable cause
A key was pressed while the
server was starting up
The keyboard is not plugged
in or connected properly
Something spilled into the
keyboard
The keyboard is defective
The mouse does not work
Probable cause
The mouse is not plugged in
or connected properly
The mouse driver did not load
when the server started
The mouse is defective
Solution
Clear the sticking key, then turn off the server,
wait for a few seconds, then turn the server
back on.
Make sure the cable is plugged in correctly.
Turn off the server. Turn the keyboard upside
down to drain, then turn it right side up to let
it dry before using the keyboard again.
Try a keyboard you know is working.
Solution
Make sure the cable is plugged in correctly.
Load the appropriate mouse driver manually or
contact Gateway Technical Support.
Try a mouse that you know is working.
System problems
83