Gateway 910 Series System Manual page 51

To install the heatsink:
1
Make sure the thermal transfer tape is centered over the processor.
2
Place the heatsink on the processor.
Caution
3
Hook the metal clip on the tab on one side of the processor socket, then
using a narrow flat-blade screwdriver, insert the tip in the top center slot
of the metal clip. Firmly press down and inward to hook the metal clip
to the processor socket tabs.
4
Connect the heatsink fan cable to the fan connector on the system board.
5
Reinstall the cover panel. (See "Reinstalling the cover panel" on page 22.)
6
Reconnect external devices, the power cord(s), and the modem cable (if
installed), then turn on the server.
Be careful not to damage the system board when exerting
force to install the metal clip on the processor socket.
Metal Clip
Screwdriver
Tabs
Replacing the processor
43