Replacing Or Adding Memory - Gateway 910 Series System Manual

Replacing or adding memory

The SDRAM DIMMs supported by your system board conform to the following
standards:
128 MB, 256 MB, and 512 MB DIMMs
PC133-compliant, Registered, ECC SDRAM
128 MB minimum system memory
2 GB maximum system memory
Single- or double-sided configurations
Memory is installed in four DIMM sockets on the system board. When you
are selecting and installing DIMMs, keep the following in mind:
No jumper settings are required for the memory size or type because the
BIOS automatically detects this information.
DIMMs must be installed in the lowest numbered slot first.
For additional DIMMs, contact Gateway.
To add DIMMs:
1
Observe the safety and ESD precautions in "Preventing static electricity
discharge" on page 15.
2
Turn off the server, then disconnect the power cord(s), modem cable (if
installed), and all external devices.
3
Remove the cover panel. (See "Removing the cover panel" on page 17.)
4
If necessary, carefully move the cables aside to gain access to the DIMMs.
Replacing or adding memory
37