Replacing The Power Supply Cage - Gateway 995 User Manual

Chapter 4: Installing Components

Replacing the power supply cage

Replacing a power supply cage may require the help of a qualified service
technician.
To replace the power supply cage:
1
Follow the instructions in
page
cords and all other cables connected to the server.
2
Remove all of the power supplies. For instructions, see
hot-swap power supply" on page
3
Remove the top rear panel, the top front panel, and the inside panel. For
instructions, see
the top front panel" on page 43, and "Removing the inside panel" on
page
4
Remove the fans and fan cage. For instructions, see
page 58
5
Remove all full-length expansion cards. For instructions, see
hot-swap expansion card" on page 82
card" on page
6
Unplug all cables from the system board. For instructions, see
the system board" on page
7
Unplug all power cables from the CD drive, diskette drive, tape drive (if
any are installed) and the hot-swap hard drive cage.
52
36. Make sure that you turn off the server, then unplug the power
"Removing the top rear panel" on page
45.
and "Replacing the fan cage" on page
84.
www.gateway.com
"Preventing static electricity discharge" on
47.
and "Replacing a standard expansion
105.
"Replacing a
41, "Removing
"Replacing a fan" on
59.
"Replacing a
"Replacing