Drive Enclosure Connection - Fujitsu ETERNUS DX60 S3 Configuration Manual

Chapter 4 Connecting Cables
4.2

Drive Enclosure Connection

1
Connect a host interface cable to the ETERNUS DX.
Insert the host interface cable connectors in the host interface ports (iSCSI) of Controller 0 (CM#0) and
Controller 1 (CM#1).
2
Connect the host interface cable to the connection destination.
Connect the other end of the cable to the connection destination.
4.2 Drive Enclosure Connection
When a drive enclosure is installed, connect the drive enclosure to the controller enclosure with a mini SAS
HD cable between enclosures.
0.75m mini SAS HD cables between enclosures are provided with drive enclosures.
The following procedure explains how to connect the mini SAS HD cable between enclosures.
Do
When connecting the host interface cables, position them so that they will
•
not obstruct replacement of the power supply unit or controllers by the main-
tenance engineer.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
47
P3AM-9002-01ENZ0