Figure 1.6 Connection Example When The Ip Address Of The Slave Cm Is Set (And A Dedicated Remote Support Port Is Used) - Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions

Chapter 1 Preparation
1.1 Connection Preparation
• Connection example with a dedicated remote support port
- For the ETERNUS DX Disk storage system, three IP addresses are required (two IP addresses for the
MNT ports and one IP address for the RMT port).
To connect the ETERNUS DX Disk storage system to both an IPv4 network and an IPv6 network, an IPv4
address and an IPv6 address are required for each port.
- An IP address is required for a PC that is used for maintenance operations performed by a
maintenance engineer.
- Network devices such as LAN switches are required for operation management.
- Network devices such as routers are required for the remote support.
- Four enhanced Cat-5 twisted-pair type LAN cables are required (two for connection to the remote
support center and two for connection to the LAN for operation management).
Figure 1.6 Connection example when the IP address of the Slave CM is set (and a dedicated remote
Administration
IP address C
Operation is performed with separate LANs for the MNT port and the RMT port.
The IP addresses of both the Master CM and Slave CM are set.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
support port is used)
SNMP
terminal manager
LAN switch
PC used for maintenance
IP address A
CM#0
Controller enclosure
ETERNUS DX Disk storage system
Copyright 2013 FUJITSU LIMITED
Mail server NTP server
Authentication
Syslog server
LAN for operation management
IP address D
This PC is used for maintenance operations.
IP address B
CM#1
Remote support
center
22
server
Router
P3AM-4832-07ENZ0