EXCV Cable Removal and Installation
Removal
1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)".
3) Remove the right under cowling assembly. Refer to
"Exterior Parts Removal and Installation in Section
9D (Page 9D-11)".
4) Connect the special tool (Mode select switch) to the
dealer mode coupler. Refer to "Self-Diagnostic
Procedures in Section 1A (Page 1A-13)".
5) After turning the mode select switch ON, turn the
ignition switch ON.
Special tool
(A): 09930–82720 (Mode select switch)
6) Check that the cable slots of the EXCVA pulley
comes to the middle (Adjustment position) "A".
7) Turn the ignition switch OFF.
CAUTION
!
Before removing the EXCV cables, be sure to
set the EXCVA pulley to the adjustment
position.
"A"
8) Loosen the lock-nut (2) on the No. 2 cable (3) and
turn in the cable adjuster (1) fully.
B838H21B06003
(A)
I837H11B0018-01
I837H11B0019-01
9) Loosen the lock-nut (5) on the No. 1 cable (6) and
turn in the cable adjuster (4) fully.
6
10) Loosen the lock-nuts (7).
11) Disconnect the No. 2 cable (3) and then No. 1 cable
(6) from the EXCV pulley (8).
8
12) Remove the EXCVA mounting bolts (9).
13) Disconnect the No. 2 cable (3) and then No. 1 cable
(6) from the EXCVA pulley (10).
3
10
Exhaust System:
4
5
1
2
3
I837H11B0020-01
6
7
3
I837H11B0021-02
9
I837H11B0022-02
6
I837H11B0039-01
1K-6