Engine Bottom Side Assembly - Suzuki GSX-R750 Service Manual

Engine Bottom Side Assembly

Assemble the engine bottom side in the reverse order of
disassembly. Pay attention to the following points:
NOTE
Apply engine oil to each running and sliding
part before reassembling.
Oil Seal / Bearing
• Install the oil seal and bearings. Refer to
"Transmission Installation in Section 5B (Page 5B-5)".
Water Jacket Plug
• Apply engine coolant to the O-rings of the water jacket
plugs.
• Tighten each plug to the specified torque.
CAUTION
!
Replace the O-rings with new ones.
Tightening torque
Water jacket plug (a): 9.5 N·m (0.95 kgf-m, 6.9 lb-
ft)
(a)
Oil Gallery Plug
B838H21406032
• Tighten each plugs (for lower crankcase) to the
• Apply thread lock to the oil gallery plug (for upper
(a)
I837H1140122-01
Engine Mechanical:
specified torque.
CAUTION
!
Replace the gaskets with new ones.
Tightening torque
Oil gallery plug (M12) (a): 15 N·m (1.5 kgf-m, 11.0
lb-ft)
Oil gallery plug (M16) (b): 35 N·m (3.5 kgf-m, 25.5
lb-ft)
(a)
crankcase) and tighten it to the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Oil gallery plug (c): 7 N·m (0.7 kgf-m, 5.0 lb-ft)
(c)
1D-55
(b)
I837H1140123-01
I837H1140124-02