Crankcase Breather (Pcv) Cover Inspection; Crankcase Breather (Pcv) Reed Valve Inspection; Evaporative Emission Control System Removal And Installation (Only For; Evaporative Emission Control System - Suzuki GSX-R750 Service Manual

1B-12 Emission Control Devices:

Crankcase Breather (PCV) Cover Inspection

Inspect the crankcase breather (PCV) cover in the
following procedures:
1) Remove the crankcase breather (PCV) cover. Refer
to "Crankcase Breather (PCV) Hose / Reed Valve /
Cover Removal and Installation (Page 1B-11)".
2) Inspect the crankcase breather (PCV) cover for
carbon deposit. If carbon deposit is found in the
crankcase breather (PCV) cover, remove the carbon.
3) Reinstall the crankcase breather (PCV) cover. Refer
to "Crankcase Breather (PCV) Hose / Reed Valve /
Cover Removal and Installation (Page 1B-11)".
Crankcase Breather (PCV) Reed Valve
Inspection
Inspect the crankcase breather (PCV) reed valve in the
following procedures:
1) Remove the crankcase breather (PCV) reed valve.
Refer to "Crankcase Breather (PCV) Hose / Reed
Valve / Cover Removal and Installation (Page 1B-
11)".
2) Inspect the crankcase breather (PCV) reed valve for
carbon deposit.
If carbon deposit is found on the reed valve, replace
the crankcase breather (PCV) reed valve with a new
one.
3) Reinstall the crankcase breather (PCV) reed valve.
Refer to "Crankcase Breather (PCV) Hose / Reed
Valve / Cover Removal and Installation (Page 1B-
11)".
Evaporative Emission Control System Removal
B838H21206008
and Installation (Only for E-33)
Hose
Removal
1) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)".
2) Remove the EVAP hoses as shown in the EVAP
canister hose routing diagram. Refer to "PAIR
System Hose Routing Diagram (Page 1B-5)".
Installation
1) Install the EVAP hoses as shown in the EVAP
canister hose routing diagram. Refer to "EVAP
Canister Hose Routing Diagram (Only for E-33)
(Page 1B-6)".
2) Reinstall the removed parts.
EVAP Canister
Removal
I837H1120023-01
1) Remove the frame cover assembly. Refer to
"Exterior Parts Removal and Installation in Section
9D (Page 9D-11)".
2) Disconnect the surge hose (1) and purge hose (2).
3) Remove the EVAP canister (3) from the bracket.
B838H21206009
Installation
1) Install the EVAP canister as shown in the EVAP
canister hose routing diagram. Refer to "EVAP
Canister Hose Routing Diagram (Only for E-33)
(Page 1B-6)".
2) Reinstall the removed parts.
I837H1120024-01
2
3
B838H21206010
1
I837H1120025-02