Suzuki GSX-R750 Service Manual page 302

1D-58 Engine Mechanical:
• Check that I.D. code "E" on each conrod faces intake
side.
CAUTION
!
Be sure to clean the conrod big end.
Piston Cooling Oil Jet
• Fit the new O-rings (1) to each piston cooling oil jet
and apply engine oil to them.
CAUTION
!
Use the new O-rings to prevent oil pressure
leakage.
"E"
I838H1140032-01
1
I837H1140133-01
• Install each piston cooling oil jet.
NOTE
Apply a small quantity of thread lock to the
bolts and tighten them to the specified
torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Piston cooling oil jet bolt (a): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
Crankshaft
1) Apply engine oil to each crank pin bearing surface
and crankshaft journal bearing surface.
2) Position the No. 2 and No. 3 conrod big ends on the
same side, and the No. 1 and No. 4 conrod big ends
on the opposite side of No. 2 and No. 3.
(a)
I838H1140033-01
I838H1140034-01
I838H1140035-01