Suzuki GSX-R750 Service Manual page 311

• While holding the generator rotor with the special tool,
tighten the CKP sensor rotor/cam chain drive sprocket
bolt (5) and tighten its bolt to the specified torque.
Special tool
(A): 09930–44520 (Rotor holder)
Tightening torque
CKP sensor rotor/cam chain drive sprocket bolt
(c): 54 N·m (5.4 kgf-m, 39.0 lb-ft)
(A)
Starter Idle Gear
Install the starter idle gear component parts (1). Refer to
"Starter Clutch Removal and Installation in Section 1I
(Page 1I-10)".
Gearshift System
• Install the gearshift cam stopper (1), bolt (2), washer
(3) and return spring (4).
2
5
(c)
I837H1140162-01
1
I837H1140163-01
4
3
1
I837H1140164-01
• Apply a small quantity of thread lock to the gearshift
cam stopper bolt (2) and tighten it to the specified
torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
NOTE
Hook the return spring end "A" to the
stopper (1).
Tightening torque
Gearshift cam stopper bolt (a): 10 N·m (1.0 kgf-
m, 7.0 lb-ft)
1
"A"
• Check the gearshift cam stopper moves smoothly.
• Locate the gearshift cam in the neutral position.
• Install the gearshift cam stopper plate (5).
NOTE
Align the gearshift cam pin "B" with the
gearshift cam stopper plate hole "C".
"B"
Engine Mechanical: 1D-67
2
(a)
I837H1140165-02
5
"C"
I837H1140166-01